I’m worried that I’m not setting the parameters correctly and instead of the ink channels each printing at 100% they are not and the ink is moving through much more slowly as a result. This seems at odds with your last comments where you talked about only needing several large sheets of paper, so I’m a little worried that I’m not doing this right. I think the online documents mention needing to print over a hundred pages and that doesn’t worry me but I have so far printed nearly 300. The ink seems to be very slowly transitioning from the colour inks to the piezo pink dye Then I have just let it print in batches of 25 sheets Select Calibration mode in the QTR dialogue with ink limit 100% Under Colour Management I select ‘Document’ (Profile sRGB IEC61966-2.1) I answer NO, Discard the embedded profileĬlick ‘Scale to fit media’ as I’m printing on A4 paper Message pops up asking me if I want to use the embedded profile Following the instructions on your ink install document online So I started printing the ink purge file but it is taking a lot of pages and I’m not at all sure I’m doing this right as neither you or Jon seem to mention it taking this many sheets.įill refill carts with piezoflush and install I’ve not sought help from the suppliers of the Adjustment Program or from the makers of Parallels yet as I have this feeling that they will both have me chasing my tails for days or weeks and I decided I just can’t waste that much time getting it working if there was another option i.e purging the ink by printing. I have tried everything I can think of to get the adjustment program to work but I just constantly get that communication error. That was the final straw and I had to walk away and count to ten…. I actually replied at length previously but lost the page when being prompted to log in.

Epson l1800 adjustment program